Hard Water

Helpful Tips When Installing a Whole House Water Filter System

You can not be 100 percent sure that the water coming out from the faucets of your home is clean and free of impurities. Although lots of issues have been solved with water regulations, the only way we can be certain of the quality of our tap water is to install a whole house water filtration system. In case your planning to set up a well filtration system, use these tips to make the installation process a whole lot easier.

Check the Installation Requirements of Your Home

man inspectingBefore you buy a whole house filter system, you should check the installation requirements to make sure the unit you buy can do the job in your home. Whole house water filters can vary in size, and many of them also need to be installed indoors or in a protected location. Not all systems fit all types of home faucets, so make sure you buy one that works for your home faucets.

This approach is sometimes overlooked by home owners. Without considering it, you’ll have to worry about the filter system backfiring, or worse, a poorly installed filter.

Use a Valve for Water Pressure

The model you buy should tell you exactly what its maximum pressure limit is. If the water pressure is too strong then you can buy a pressure reducing valve separately and attach it to your fixtures. Keep in mind that pressure can vary overnight. Sometimes nighttime pressure can be more effective than daytime pressure. Thus it is advisable to check at different times of the day and night to determine if you may need a pressure-reducing valve.

Connect Your Filter System Directly to the Main Supply

water filterMost water filtration systems are designed to work with hard water and can be damaged if the system uses water from the water heater. Also, do not run hot water through the system when cleaning, as this can damage the system. However, you should place the system in a place where the water in the machine will not clog, especially during the winter months.

Install a Pre-Filter Before the Filtration System

Depending on the water quality of your home, a pre-filter is necessary to help you produce the cleanest water possible and extend the lifespan of the water filtration system installed after. You can also provide a system to bypass waterways. This will make it easier to replace the pre-filter and troubleshoot any problems that may arise.

Leave a Reply

Your email address will not be published. Required fields are marked *